MaxLine Solutions MaxLine help desk
Knowledgebase

Hello, how can we help?

Suggested knowledgebase articles:

Knowledgebase

Niagara
MIG112
MIM312
  • Top articles
  • Latest articles
Signature/Unlock Code

Category: Licenses

Follow the step as below to insert the signature:- Open the JACE station. Navigate to config and Services folder. Click XXXLicenseService. Click right mouse button, Action -> License Updated. ...

45
(1)
3rd Party Module Installation

Category: Module Installation

To install the 3rd party module follow the step as below:-

24
(0)
Chiller Negative Analog Reading

Category: Trane - CommFour

Issue Some of the chiller model may required some optional setting whenever all the analog value reading turn to negative values. Solutions Go to Chiller device properties sheet and change the chille...

21
(1)
License Backup

Category: Licenses

To backup the existing license before cleanDist or upgrading the Niagara version, follow the step as below:- Open the JACE platform. Navigate to platform and look for "File Transfer Client". Left han...

21
(1)
Write Value Failure

Category: Trend

Issue The controller has no PIN setup, however when Niagara trying to write a value without a PIN it still responds "PIN error" failure. This is because the Niagara PIN property is read a wrong proper...

19
(0)
Module Installation

Category: NW8K - Asd

The NW8K "ibmsAsd" driver required additional dependency module "vsp-rt". Please ensure the "ibmsAsd" module come along with the "vsp-rt" module before install to the target JACE. Please contact techn...

19
(0)
Linux Filesys

Category: MIG112

Some cases the MIG112 is running with the older Linux filesys. We required to update the Linux filesys to support the latest firmware driver. Without the latest Linux filesys the latest firmware drive...

18
(0)
Communication Unstabled - Bus Address Issue

Category: Honeywell - Cbus

Issue Some of the cases the communication keep up and down too frequently, you will notice the MIG112 TX/RX LED transmit for few second and stop. This is because of the network has a duplicate Cbus ID...

11
(0)
Communication Unstabled - Signal Issue

Category: Honeywell - Cbus

Issue The old designed of the RS485 controller is using 3.3v power supply. Some of the cases this may cause the communication unstabled or the communication state up and down too frequently. This may ...

12
(0)
Communication Unstabled

Category: CSI Inet

Issue Some of the cases the controller received very short of response data. This will cause of the device is down and become unstabled. Solutions Increase the inter message delay to 250ms ( valid ran...

12
(0)
Communication Unstabled

Category: Trane - CommThree

Issue Some of the cases the controller received very short of response data. This will cause of the device is down and become unstabled. Solutions Increase the inter message delay to 250ms ( valid ran...

16
(0)
Discover Missing Controller

Category: Robertshaw - Microsmart

By default the configuration of the minimum and maximum controller allowed in the network is 1 - 64. To allowed more controller, access to the MIG112 web browser and navigate the Connector X where X i...

14
(0)